The Butler is a simple pushbutton transmitter that activates any LRS pager. The alphanumeric pager can
be customized with any message up to 200 characters.
The Butler has two main functions:
A Pushbutton Transmitter
Each of the four buttons can be programmed to transmit a specific message depending on the pager type
being used. Battery operation allows the Butler to be mounted virtually anywhere. Great for instructing
staff to report to specific areas as they are needed.
An Alert System
The system can be integrated with 4 independent sensors which can be used to monitor entrances and exits
and can be configured in any combination of normally open or normally closed. When the sensors are
tripped, the butler transmits a signal to a pager(s) notifying the recipient which trigger has been
tripped. (Ideal for any sensor - temperature, door, water level, etc.)
Increase efficient facility operations by communicating with staff silently
Ideal for connecting to any sensor, such as temperature, door, water-level, etc.
Battery operated so you don’t need to be near 110V outlet.
Customized messages for different triggers instruct staff specifically and immediately
We recommend the use of HIGH QUALITY batteries for
all products that use non rechargeable batteries and where non
rechargeable batteries are used we do NOT recommend rechargeable
batteries. Alkaline batteries are the minimum requirement standard
for all non rechargeable batteries. Low quality batteries give poor
results with reception or transmission of signals and often leak
when they run low. We recommend DURACELL batteries.
Please note
that if batteries leak in to equipment and damage the equipment then
that equipment damage is NOT covered under warranty. In that
situation please refer to the battery manufacturer for a claim for
the cost of repair of the product.
